- 16 -
SPARK PLUGS
NOTE
Use the Plug Wrench supplied with this unit.
(
1
)
Clean off carbon deposits on the spark plug electrode using
a plug cleaner or wire brush.
(
2
)
Check electrode gap. The gap should be 0.6mm to 0.7mm. Adjust
the gap, if necessary, by carefully bending the side electrode.
Recommended Spark Plug: CR5HSB (NGK)
NOTICE
!
An incorrect spark plug can cause engine damage.
For good performance, the spark plug must be properly gapped and free
of deposits.
1
、
Disconnect the spark plug cap, and remove any dirt from around the
spark plug area.
2
、
Remove the spark plug with a 5/8-inch spark plug wrench.
DANGE
!
Be careful not to touch the muffler while it is hot.
3
、
Inspect the spark plug. Replace it if damaged or badly fouled, if the
Summary of Contents for TRE-75 TAMPING RAMMER
