- 5 -
sure that no one be endangered by machines turning over by slipping or
by moving machine parts.
3.
Drain the used oil when being transported on vehicles, precautions
have to be taken that vibration plates do not slip or turn over.
The following should be taken to prepare your TRE-72
Tamping Rammer for extended storage.
1.
Close fuel shut off valve.
2.
Store the unit in an upright position in a cool, dry, well ventilated
area.
3.
Siphon excess gasoline from tank.
4.
Start engine until it stops from lack of fuel. This will use up all the
fuel in the carburetor and prevent formation of deposits due to
evaporation of fuel.
5.
Remove spark plug and pour 2 oz. of SAE-30 or SAE-40 motor oil
into the cylinder. Slowly crank the engine 2 or 3 times to distribute
the oil throughout the cylinder. This will help prevent rust during
storage. Replace spark plug.
DANGER!
Gasoline is extremely flammable,
do not smoke or handle open fire near this
machine.
6.
Change the engine oil (See page 10).
7.
Pull the starter grip slowly until resistance
is felt and the notch on the starter pulley aligns with the hole at the
top of the recoil starter cover. This will close the valves so moisture
cannot enter the engine cylinder. Return the starter grip gently.
Summary of Contents for TRE-75 TAMPING RAMMER
