10 www.DynamiteRC.com
Dynamite Ultra AC/DC Charger/Cycler
A. D>C means that the charger will discharge
first, then charge.
B. C>D means the charger will charge first,
then discharge.
C. D/1 flashing means the charger is in the
discharge process and will charge when the
discharge mode is complete.
D. C/1 flashing means the charger is in the
charging process and will discharge when
complete.
E. D/1 alternate flashing designates that the
charger is in the cool down time period after
discharging.
F. C/1 alternate flashing designates that the
charger is in the cool down time period after
charging.
Charge and discharge capacities in mAh will be
displayed after the cycle is complete.
li-ion, li-Po and li-Fe
Charge Mode
warning:
Li-Po batteries can cause serious injury and fire
if charged inappropriately. Always confirm the
battery voltage and series cell count is correct
and never charge higher than a 1C rate. (1C
= charger current equals the battery capacity.
Example: A 1000mAh battery’s charge current
limit is 1 amp. Example B 3300mAh battery’s
charge current is 3.3A)
Li-Poly Charge
4.0A 14.8V(4S)
Message during li-ion/Poly Charging
Is 14.8V(4S) ?
No=Stop/Yes=Ente
Confirm if the number of selected battery cell
is correct. To select the correct voltage, use the
following formula to calculate the voltage of
your pack: 3.7V/cell (e.g. 4S = 4*3.7=14.8V). Be
careful to confirm the correct voltage and cell
count. Failure to due so may result in damage
or fire.
