Dynamix DW-2FXS/2FXO Gateway (H.323) User Manual
Parameters Usage:
print current h323 related settings
-mode alternatives for gatekeeper or peer-to-peer mode (0=gatekeeper
mode; 1=peer-to-peer mode). If users select gatekeeper mode, a
valid gatekeeper is needed when Gateway is in operation.
-----------------------------------------------------------------------------------------------
usr/config$ h323 –mode 1 (peer to peer mode)
-gk
to assign gatekeeper’s IP address when Gateway is in gatekeeper
mode.
-algk
assign second gatekeeper’s IP address as redundancy. If
Gateway fails to register to main GK for 10 time, it will try to
register to alternative GK.
-gwtype gateway type has two kinds, gateway and terminal. Gateway
type – device will register as H.323 defined Gateway, user has to
define [prefix] in next command.
Terminal type – device will register as H.323 defined Terminal,
[prefix] command is not necessary.
-dfgw
default gateway is applied under
Peer-to-Peer mode
. User defines
a constant default gateway IP address, then any number dialed if
the number is not listed in phone book table will pass forward to
this IP Address.
-prefix assign Gateway prefix number, as well as the registered number
on the Gatekeeper.
-line1
assign FXS TEL1 number.
-line2
assign FXO Line1 number.
-line3
assign FXS TEL2 number.
-line4
assign FXO Line2 number.
Note:
User can also set “x” in line number to disable the port. If the port is
disabled, it can only receive calls but not calling out.
86
