Dynamix DW-2FXS/2FXO Gateway (H.323) User Manual
Parameter Usages:
print out all current settings of line
-config determine which line to configure
-hunt
set hunting group flag of each line. User can assign different hunt
group number represent different hunt group. For example, if user
assigns FXS TEL1 as hunt group 1, and FXS TEL2 as hunt group
2, they will be determined as 2 different groups. On the other hand,
if user assigns FXS TEL1 as hunt group 1, and FXS TEL2 as hunt
group 1 too, when having incoming call to FXS TEL1, which is
busy, this call will be route to FXS Line2.
Note: FXO Lines and FXS TELs are treated as 2 different groups,
so even they are in the same hunt group, call will only be routed
to the same FXS or FXO Lines.
-hotline set hotline table.The Hotline Mode is applied in limited two
channels. User just picks up the phone set of one FXS TEL or calls
in one FXO line, and gateway will automatically dial out a phone
number. In the other hand, user will hear ring back tone or dial tone
immediately depended on configurations of destination device.
Note: This function can both work in GK or P2P mode.
(1) Call out from FXS Line
GK Mode Usage:
Set gateway under gk mode.
Create a Hotline table with “
line
” command.
-------------------------------------------------------------------------------
usr/config$ line –config 1 hotline 1001
-------------------------------------------------------------------------------
In this example means: if user picks up phone set of FXS Line1,
gateway will automatically dial out “1001”.
P2P Mode Usage:
Set gateway under P2P mode.
Create phone book table with “
pbook
” command.
89
