Dynamix 8Ports 4-Band VDSL IP DSLAM User’s Manual V.3
General Rules
Before making any connections to the IP DSLAM, note the following rules:
Ethernet Port (RJ-45)
All network connections to the IP DSLAM Ethernet port must be made using Category 5 UTP for 100/1000Mbps and
Category 3,4 UTP for 10Mbps.
No more than 100 meters (about 328 feet) of cabling may be use between IP DSLAM or with HUB or an end node.
•
VDSL Port (RJ-45)
All home network connections to the VDSL Port
made using 18 ~ 26 Gauge phone wiring.
•
We do not recommend using 28 Gauge or above phone line.
Connecting the IP DSLAM
The IP DSLAM has 2 10/100/1000 Mbps Giga Ethernet ports which support connection to 10/100/100Mbps Giga
Ethernet. Support full or half-duplex operation. The transmission mode is using auto-negotiation. Therefore, the
devices attached to these ports must support auto-negotiation unless they will always operate at half duplex. If
transmissions must run at full duplex, but the attached device does not support auto-negotiation, then you should
upgrade this device to a newer version that supports auto-negotiation and auto-crossover(MDI/MDIX).
Connecting “MDI-X” Station Port
1. You can connect the “9,10” port on the IP DSLAM to any device that uses a standard network interface such as a
Cable modem, ADSL modem, Ethernet Switch, workstation or server, or also to a network interconnection device
such as a bridge or router (depending on the port type implemented).
2. Prepare the network devices you wish to connect. Make sure you have installed suitable VDSL Modem before
making a connection to any of the IP DSLAM (1-8) station ports. You also need to prepare 18 ~ 26 gauge one twist
16
Return to the catalogue.
