Dynamix 8Ports 4-Band VDSL IP DSLAM User’s Manual V.3
•
In band Management :
IP DSLAM provides a console port for setup IP or other function.
•
Out of band Management:
IP DSLAM supports remote control by Telnet and Web-based.
Management easy-to-use configuration and ongoing monitoring. This software is
embedded in the VDSL IP DSLAM and delivers remote, intuitive management of IP
DSLAM and connected VDSL CPE devices through a single IP address. IP DSLAMs are
easy-to-configure and deploy, and offer a compelling option in terms of cost,
performance, scalability and services compared to traditional ATM-based xDSL solutions.
•
IEEE-802.1d Spanning tree:
This function is for MAC bridge to avoid port loop and link redundant.
•
IEEE-802.1ad port trunking:
Namely link aggregation
•
Port Mirroring:
This function could be mirroring and duplicate client side action as E-Mail, but need to be with mirroring
AP as Session Wall or others.
•
Broadcast storm filtering:
This function is for avoid connecting node too much cause broadcast storm.
•
TFTP protocol:
This function is for remote firmware upgrade, and remote setup value backup and restore.
•
SNMP:
Support RFC-1493 bridge MIB; RFC-1213 MIB II; RFC-1643 Ethernet
MIB and RFC-1757 RMON MIB with 1,2,3,9 groups
•
SNR(Signal to Noise Ratio) indicator :
This function is for checking CO and CPE both connecting quality over phone
wiring.
•
Alarm
:In order to make sure system normal working, IP DSLAM provides Fan and Temperature monitor and
management, you can through WEB or Telnet to show internal temperature and Fan speed, if
temperature
exceeds 70
°C or
Fan speed stops, the IP DSLAM
will send a SNMP trap to inform of Trap management
server.
•
Hacker prevention:
To avoid hacker to enter management system through client side, the 8 ports IP DSLAM will filter
system IP from client side for preventing hacker attacking.
3
Return to the catalogue.
