FXS H.323 VoIP Gateway User Manual
-http: Assiged Gateway web browser connection port number, default port number 80.
-lanip: Specify LAN port IP address (For NAT function), use this command setup lanip
address assigned to PC or other machine. Setting IP address provide PC setup
Default Gateway Address.
usr/config$ ifaddr -lanip 192.168.124.124
Note:
One Group only use only LAN IP address, if have two gateway on this group, you must
change second gateway LAN IP Address different first gateway.
Gateway First:
usr/config$ ifaddr -lanip 192.168.124.124
Gateway Second:
usr/config$ ifaddr -lanip 192.168.124.125
Important Note:
This command function only 1FXS (FXS-01) VoIP Gateway used. So, other mode VoIP
Gateway not sees it.
-sntp: Simple Network Time Protocol (0=No update, 1=Specify server IP, 2=broadcast mode).
When SNTP function is activated, users have to specify a SNTP server as network time
source. An example is demonstrated below:
usr/config$ ifaddr -sntp 1 10.1.1.1
Note:
While 10.1.1.1 stands for SNTP server’s IP address.
-timezone: set local time zone according to GMT
-ipsharing: To specify a global fixed IP address, user can add this IP address in the command.
usr/config$ ifaddr -ipsharing 1 210.11.22.33
Note:
If the IP address is not a fixed one, the dedicated IP address is not necessary in the
command. However, dynamic IP Address is not working in Peer-to-Peer mode.
-ipchange: If the unit is behind the IP sharing device and the IP address for the WAN port of that
IP sharing is using the dynamic IP address. This function has to be enabled.
usr/config$ ifaddr -ipchange 1
-id: This id is for the user name of the PPPoE usage.
-pwd: This password is for the user name of the PPPoE usage.
-reboot: If the connection disconnected by the ISP, the unit will reboot and get the ip again.
For example:
usr/config$ ifaddr –print
- 99 -
