Dynamix IAD -162 Gateway
2.1.3.3 Application mode-Proxy/Peer-to-Peer Mode
After setting IP address, user must assign IAD to work under Proxy mode or
Peer-to-Peer mode. If there is no Gatekeeper, please set your D y n a m i x IAD 162
as Peer-to-Peer Mode.
2.1.3.3.1 Proxy mode
Proxy mode means that there will be an intermediate Proxy Server between
Dynamix IAD -162 Gateway and the remote entity. While operating at this mode,
Dynamix IAD -162 Gateway will first register to the Proxy Server located at the ISP
side. For the following operation, it sends the INVITE message to the Proxy Server
once you initiate a session. Then the Proxy server will forward the INVITE message
to the right place. And the Response message from the remote entity will be
forwarded back to you via Proxy server.
Step 1.
Configure the Dynamix IAD -162 Gateway SIP Configuration. Click SIP
Information on the navigation panel. In the SIP Information screen, select
Proxy routed Mode function.
Step 2.
Set the SIP information from your service provider: Proxy IP Address, Line1
Number, Line1 Account, Line1 Password, and click the OK button.
Note:
1. Please contact with your Proxy vendor to obtain user account information.
2. If no need to enter password, user also has to set security information, please
set “name” the same with line number.
3. Dynamix IAD -162 Gateway uses “line number” to register to proxy server, the
“name” is only for authentication.
- 15 -
