121 – 18799 AIRPORT WAY, PITT MEADOWS, BC, CANADA, V3Y 2B4
PHONE: 604-465-0009
WEB PAGE:
www.dynanav.com
EMAIL:
airag@dynanav.com
FAX: 604-465-0084
6
The display should be mounted to best suit the requirements of both the pilot and the specific
aircraft/helicopter. This should take into consideration the following:
It should be in the direct view of the pilot, so as not to obstruct his view outside the aircraft.
The sun shroud (used on the EL type display) should be positioned for full screen visibility for the pilot while
occluding direct sunlight on the screen. As the bottom mount can be tilted from 0 to 45 degrees to adjust for
individual pilot needs, be sure the bottom plate is mounted to allow for individual pilot needs (tall or short).
The front of the screen should be oriented to front of helicopter/aircraft to give guidance information that
relates to helicopter/aircraft flight direction.
Product features
The connector plug for the DynaViz™ display can be switched from side to side to meet installation
requirements whether harness enters from either left or right side.
As the display represents the ground view, the display should be mounted as horizontal as possible so as
the pilot can see the complete screen. The EL display can be viewed a quite extreme angles and can use
either the tunnel sun shroud or the angled sun shroud.
The connector plug is a LEMO connector that is simply pushed on (align red dots first) and simply pulled off
to remove.
