7
LG140/160/200 ILG140EN4
SAFETY WHEN DRIVING
Max 20°
or 36%
Tilting
Driving on slopes
L000505A
Max 20°
or 36%
L000504A
Tipping angle on side slopes
Driving near an edge
At least
2/3
Machine location when operating
on edges
L000503A
When driving near an edge, at least two thirds of the
plate must be on firm solid ground.
If the machine tips over, switch off the en-
gine before attempting to lift.
Make sure that the work site is safe. Wet and loose
earth reduces manoeuvrability especially on sloping
ground. Always observe particular caution on sloping
and uneven terrain.
Where possible, avoid all driving across a
slope. Instead, drive up and down on sloping
ground.
Never work on slopes that are greater than the capa-
bility of the machine. Maximum slope of the machine
in operation is 20° (depending on condition of the
ground).
The tilting angle is measured on a hard, level surface
with the machine stationary. Vibration switched OFF
and all tanks full. Remember that loose ground, vibra-
tion switched ON, and driving speed can all cause the
machine to topple even on a smaller slope than speci-
fied here.
Never leave the machine unattended with the
engine running.
