17
ILH800EN2
In transport mode, the transmitter should be placed
under the rear hood.
Before start
OPERATION – RADIO REMOTE CONTROL UNIT
1. Open the rear plastic hood and take out the
transmitter. Insert and turn the battery disconnecter
(14) to locked mode. The beeper sounds (15) when
power is switched on. The beeper stops as the
engine starts.
Starting the engine
10. Transmitter
11. Antenna
12. Emergency stop knob
13. Receiver
14. Master switch
15. Buzzer
10
12
11
13
15
14
2. Close the hood and pull out the emergency stop
knob (12) on the machine.
3. Switch the transmitter (5) on. A green LED (4)
indicates when the transmitter is on.
4. Check the battery status. The low-battery warning
light (6) should not light. Always have an extra fully-
charged battery available.
Wait 4–5 seconds. The time it takes for the
transmitter to open communication with the
receiver.
5. Set the engine revs switch (2) to “low” mode
(tortoise).
6. Press the start/stop switch (7) forward until the
engine starts. Release the start/stop switch as the
engine starts.
7. A new attempt to start can be made after 7 seconds.
12
12. Emergency stop knob
2. Speed switch, High/Low
4. Transmitter indicator, On
5. Transmitter switch, On/Off
6. Low battery voltage
7. Start/Stop switch, engine
Never use start gas.
L000329A
L000338A
2
4
5
6
7
WARNING
CAUTION
L000582A
