E 10
E_EB3
4_VB340
__05.
08_G
B.
fm
-14 02-
05.
08
4
Settings
4.1
Setting extendable parts
Should you need to readjust the extend-
able parts, this setting can be undertak-
en while the screed is fitted on the
finisher.
Basic setting:
- Unfasten retaining bolts (1) and lock
nuts (3).
- Adjust adjustment screws (2) and
(3a):
A
Raise extendable part: turn adjustment
screws (2) to the right and turn lock nut
(3) and/or adjustment screw (3a) to the
left.
m
All adjustment screws must be set to the
same height! This is the only way of en-
suring that no scraping occurs during in-
stallation.
A
The extendable parts must be set to
3mm higher than the main screed!
- After the setting process:
retighten retaining bolts (1) and lock
nuts (3).
Fine adjustment, setting during in-
stalling work:
- Unfasten fastening bolts (1), screw (4)
and nut (4a).
- Perform fine adjustment by turning the
setting nut (4b).
- Tighten down retaining screws (1) as
well as screw (4) and nut (4a) to se-
cure the adjusting nut.
1
1
2
4b
4a
Einstell1_340.wmf/Einstell4_340.wmf
4
3a
3
Summary of Contents for Svedala Demag EB 34 Series
