HEIGHT ADJUSTMENT
1. Inspect all parts for shipping damage before
assembly. If there is shipping damage –
DO NOT
USE
. Contact dealer/carrier for further instructions.
2. Make certain that the height adjusting brass
push-pins fully protrude through the same respective
hole of each leg extension. This will ensure that the
leg extensions are securely locked in position and an
even height is achieved.
3. Ensure ALL screws, nuts and/or bolts are tightened.
4. Check the rubber tips on the leg extensions for rips,
wear or if they are missing. Immediately replace any
or all if any of these imperfections exist.
5. All four leg extensions with rubber tips MUST touch
the floor simultaneously.
6. When used in a tub, make certain the rubber tips are
not touching the sides of the tub wall.
7.
DO NOT
stand on chair.
NOTE:
To maintain the beauty of the original finish,
clean with mild soap and rinse with warm water.
Wipe bath seat dry after each use.
1. Before use, adjust height of each leg
to your specific needs, making sure
all legs are at the same height. When
desired height is reached, lock legs
into place by aligning buttons into
proper holes, per illustration.
2. Make sure legs are locked into place
by pushing down on or pulling legs.
WARNING
ASSEMBLY INSTRUCTIONS
PRODUCT LIST
Weight Capacity: 400 lb. (180 kg)
4 Legs
Chair Base
1. Lay the chair base with the seat surface facing down
and the leg sockets facing up.
2. Depress the brass push-pin and insert the leg into
the socket until the brass push-pin “snaps” through
the hole.
3. Repeat step 2 with the other three legs.
4. Turn chair upright.