Spa Operator’s Guide
Sec1:23
SPA (XM2) CONFIGURATION
Select button is used to access the phase configuration setting
menu (short press) as well as the low level programming
menu (press and hold for 5 seconds). Subsequent presses
will save changes and display the next option available or exit
automatically if it was the last one.
Use change button to change the parameters displayed.
Press and hold select button for 5 seconds to activate low level
programming. Once activated, the display shows “LL” and, in
succession, the current preset low level configuration selected.
(refer to page 24 for configuration number)
Press change button repeatedly to select the
the same preset low level configuration again.
Press select to confirm. You will exit menu automatically.
The in.xm2 will then reset. After resetting, the system starts a
“learning sequence” in which each individual output is activated
and its peak current displayed and saved.
Note: This procedure has to be performed after every learning mode.
NOTE!
Note: If unusual current readings e.g.: 4 to 6 amps are detected on
the high speed of any pump, all pumps must be primed and the
learning mode should be restarted.
NOTE!
The in.xm pack has the ability to verify and “learn” the current consumption of
every output connected to it. If an output is replaced, a new learning must be
done. Follow these simple steps:
+
L1
L2
N
G
+
L1
L2
N
G
+
L1
L2
N
G
+
L1
L2
N
G
+
L1
L2
N
G
+
L1
L2
N
G
Description
Setting the learning mode
Summary of Contents for Spa & Hot Tub 2016
