Input terminal Right and Left / Input terminal Mono
This subwoofer provides 3 low level inputs: Left, Right, and Mono. These inputs can be used
in any combination. Signals from all 3 inputs are summed and fed to the subwoofer.
Do
not
connect any of these inputs to high level signals such as power amplifier speaker
outputs!
If a
SUB OUT
terminal (or equivalent) is not present on the pre-amp/processor, then connect
the subwoofer via
PRE OUT
to <IN R> and <IN L>.
Output switch / Output terminal Right and Left
The output terminals are intended for use when a separate power amplifier or integrated
amplifier with separate inputs is available.
Using this output enables the removal of frequencies below 80 Hz from the main speakers by
setting the switch to < Lowcut 80 Hz>.
With the output switch in the <Flat> position, the input terminals are connected directly to
the output terminals. With the output switch in the <Lowcut 80 Hz> position, the signal
passes through an active second order (12 dB/octave, f
-3dB
= 80 Hz) high-pass filter. This
selection cuts frequencies below 80 Hz to the main speakers, thereby reducing potential
distortion.
Summary of Contents for Audience SUB-20A
Page 1: ...Audience SUB 20A Audience SUB 30A Owner s Manual and Safety Instructions ...
Page 17: ......
Page 19: ...Fax 45 86 52 31 16 ...
