5
2.2 Mains and power connections
Your Dynaudio Music speaker requires connection to mains power.
Use the mains cable supplied with the speaker. Music 1 is additionally
supplied with an external power supply.
Music 1 and Music 3 incorporate an internal rechargeable battery that
enables them to be used while disconnected from mains power. The
battery will charge while mains power is connected.
Music 1 and Music 3 battery level is displayed by the Dynaudio Music
App but can also be established by a short press of the
Power
button
when the unit is switched on and unplugged from mains power. The
volume indicator array will illuminate for a few seconds. To indicate a
fully charged battery all the indicators will illuminate. To indicate 50%
charge half the indicators will illuminate. When the battery charge falls
below 3% the first indicator will flash slowly and the volume level will
reduce. When the battery level falls to 1% the speaker will switch off.
In normal use Music 1 and Music 3 battery life is eight to ten hours
following a full charge.
Note: Music 1 and Music 3 are shipped with a battery charge level of
between 70% and 80%.
Note: Dynaudio Music speaker models have two standby modes:
Network Standby and Deep Standby. In Network Standby mode, Wi-Fi,
Bluetooth, remote control and amplifier functions remain active to enable
the speaker to play in response to app and remote handset commands
or a wired input signal. In Deep Standby mode all functions are disabled
to save power.
A speaker can be woken from Deep Standby mode by pressing an
on-body or handset button, connecting a wired source cable and, in
the case of Music 5 and Music 7, by triggering the proximity sensor.
Standby modes are indicated by red illumination of the first volume
indicator.
2.3 Switching-on and Standby Modes
To switch on a Music 1 or Music 3 press the
Power
button.
Note: If Music 1 and Music 3 are in Standby mode they can be switched
on by pressing any on-body or handset button.
Music 5 and Music 7 incorporate proximity sensing, so to switch on,
simply bring your hand close to the top panel.
Note: Music 5 and Music 7 will also switch on following a button press or
audio cable connection.
Your Dynaudio Music speaker will switch on automatically from
Network Standby mode in response to a Wi-Fi or Bluetooth stream, a
USB connection, or an audio signal present on one of its wired inputs.
All Dynaudio Music speaker models will switch to Network Standby
mode by default after ten minutes of inactivity. Power dissipation in
Standby mode is less than 3 Watts.
Following ten minutes in Network Standby mode without an active Wi-
Fi or Bluetooth connection, the speaker will switch to Deep Standby
mode in which power consumption is less than 0.5 Watts.
Note: If there is no active Wi-Fi or Bluetooth connection when the
speaker first enters Standby mode it will immediately default to Deep
Standby mode.
Dynaudio Music speakers cannot be switched manually into either
standby mode. Music 1 and Music 3 can be fully switched off by
pressing and holding the
Power
button for two seconds. Music 5 and
Music 7 can only be switched off fully by disconnection from mains
power.
