FAQ FOR THE DYNAVIN N7-MST2010 PRO
FORD MUSTANG 2010-2014
N7-MST2010 PRO FAQ| © DYNAVIN NORTH AMERICA
14. How do I pair my phone to the Dynavin via Bluetooth?
You do not need to do anything on the Dynavin besides turn it on. The pairing is done entirely on the phone.
Find the Dynavin in your phone's Bluetooth menu and select it. If your phone asks to pair to the Dynavin,
select Yes or Pair. It may also ask for permission to access your contacts. Select Yes or No. The pairing code, it
’
s
1234.
15. What are these SD cards for?
The smaller micro SD card has the navigation program and map data on it. It must be inserted into the “NAV”
card slot on the front lower panel of the Dynavin radio. The larger "card" is simply an adapter to the larger
more common SD card size which is often inserted in a computer to download firmware updates, images, or
other media.
16. Can the boot logo/startup screen image be changed?
Yes. Any picture stored on an SD card or USB (JPG, PNG or BMP format) can be used as the boot screen. Make
sure the card is 32gb or LESS and the pixels of the image are as close to 1024 x 600 as possible as this is the
resolution of the radio. To change the boot screen, access the USB or SD Card menu.
Go to “Images”.
Find the
image you want, select the it so it displays on the screen, and press the icon in the bottom left corner. The
selection will be confirmed when the icon shows a green check mark.
17. Where should I install the microphone?
The microphone should be placed in front of the driver. Some trial and error may be needed for best results.
Typically, the area near the dome lights or at the top of the A pillar works best. In the Bluetooth Phone
settings menu there is a setting for
“
mic gain
”
. This setting can be used to fine tune the sensitivity of the
microphone to work best for the user’s voice level, ambient car noise, etc.
More audio settings are available in
the “Audio” menu from the main menu.
18. Where should I install the GPS antenna?
The easiest place to install the GPS antenna is inside the dash behind the stereo. Since the dash frame is
metal, the magnetic GPS antenna will stick to it. Placing the GPS antenna on top of the highest crossmember
facing up usually yields good results. If for any reason the reception is not good, alternate locations include the
outside of the car, the roof, trunk lid, or cowl area.
III. TROUBLESHOOTING
19. My steering wheel controls are not working.
Check that the 4-pin plug on the main harness is connected to the back of the radio and if it is, unplug it and
make sure to plug it in the correct direction so it is keyed properly. This is a common install error.
20. I plugged in the main harness and the Dynavin will not turn on.
See #19 above.
Check the battery: will the car start? Car audio installations can be hard on a car's battery as the doors are
open, lights on, key in, for long periods of time which can run down the battery or push a battery that is
