8
Charging the Battery
When the battery charge is low, the T10 will emit an audible beep. You should plug in your T10
and recharge the battery immediately.
1.
Plug the charger supplied with your T10 into a wall outlet.
2.
Connect the charger to the charger port on the device (Page 5, #10).
The charging indicator (Page 4, #1) will glow amber while your T10 is charging. It will turn
blue when it is fully charged.
3.
After your T10 is fully charged, disconnect the charger.
You
can’t
overcharge the battery. It is fine to charge the battery overnight.
You
can
use the T10 while the battery is charging.
The battery model is 5860103P/4000mAh/7.4V.
C
AUTION
Because of internal chemical reactions, battery performance may deteriorate over time. In
addition, failure to keep the conditions of use (charge, discharge, ambient temperature, etc.)
within specified ranges may shorten the battery life expectancy, or damage your T10. If the battery
cannot maintain a charge for long periods of time, even when it is charged correctly, it may need
to be replaced.
C
AUTION
For safe and proper operation of your DynaVox T10, use only chargers, batteries, and
accessories that have been approved by DynaVox Technologies.