DX-WBRDVD1/DX-WBRDVD1-CA
31
2
Press
or
to
select
Audio
. The
Audio
menu opens.
3
Press , then press to select
Digital Output
, then press
ENTER
.
4
Press or to select the digital output mode you want, then press
ENTER
. You can
select:
•
PCM
—Sends a PCM audio signal of up to 7.1 channels over the HDMI connection
and up to 5.1 channels over the coaxial connection.
•
Bitstream HD
—Lets your player send Dolby TrueHD or DTS-MA bitstreams over
HDMI (if your player is connected to a compatible HDMI audio receiver). If your
player is not connected to a compatible HDMI receiver (for example, your player is
connected directly to the TV or your player is connected to an audio receiver using a
coaxial cable), a compatible audio signal is automatically sent over the HDMI and
coaxial connections.
With this setting, Blu-ray audio is limited to the soundtrack for the main movie (no PIP
audio).
•
Bitstream Legacy
—Sends a DTS or Dolby Digital bitstream from the disc over
the HDMI and coaxial connections. Blu-ray audio is limited to the soundtrack for
the main movie (no PIP audio).
•
Bitstream mixed
—Sends a mixed (PIP audio and movie audio) DTS audio
stream over the HDMI and coaxial connections. This mode is primarily intended for
use when you want to hear both PIP audio and the movie audio.
5
Press to go to the previous menu.
Turning dynamic range control on or off
Dynamic range control is only active when a Dolby Digital signal is detected.
When
Dynamic Range Control
is set to
Off
, movie soundtracks are played with the
standard dynamic range.
When movie soundtracks are played at low volume or from smaller speakers, you can set
Dynamic Range Control
to
On
. Your player applies appropriate compression to make
low-level content more intelligible and prevent dramatic passages from getting too loud.
When
Dynamic Range Control
is set to
Auto
, the system turns on the Dynamic range
control for all BD movie soundtracks except Dolby TruHD. If you have selected a Dolby TruHD
track on the BD disc, Auto tells the BD player to only turn on dynamic range control if
information embedded in the Dolby TruHD sound track tells it to do so.
To turn dynamic range control on or off:
1
Press
ENTER
. The
Settings
menu opens.
2
Press
or
to
select
Audio
. The
Audio
menu opens.
Settings
Audio
Network
Display
Display
HDMI Status
HDMI preferred Format
Resolution
TV Aspect
Film Mode(1080p24)
Deep Color
Connected
1080P
HDMI Auto
16:9 Original
Off
Auto
System
Language
BD-Live
Parental
DX-WBRDVD1_11-0366_MAN_V3.fm Page 31 Monday, April 18, 2011 12:58 PM