DX-WBRDVD1/DX-WBRDVD1-CA
41
6
If your network does not use encryption, press or to select
Connect
, then press
ENTER
. If the wireless network is working, you should see a checkmark and a
connected message on the TV. If the message does not appear, repeat the steps above.
OR
If your network uses encryption:
1
Press or to select the
Password
field, then press
ENTER
. An on-screen keyboard
opens.
2
Press or to select the first letter in the password, then press
ENTER
. Repeat
this step to enter the rest of the password. If you make a mistake, use the
Clear
key to
delete the character.
3
After you enter the password, select the red
Done
in the upper left-hand corner of the
keyboard, then press
ENTER
to close the keyboard.
4
Press or to select
Connect
, then press
ENTER
. If the wireless network is working,
you should see a checkmark and a connected message on the TV. If the message does
not appear, repeat the steps above.
Setting up WiFi protection (WPS)
To set up WiFi protection (WPS):
1
Press
ENTER
. The
Settings
menu opens.
2
Press
or
to
select
Network
.
3
Press , then press to select
WiFi Protected Setup (WPS)
, then press
ENTER
. A
screen appears, asking you to press the button on your router.
4
Press the button on top of your router. A screen should appear on your TV that says
“Success” when your player is connected to the router. Press
ENTER
to close the
message.
5
Press to go to the previous menu.
Manually setting access point entry
To configure the wireless Internet connection:
1
Press
ENTER
. The
Settings
menu opens.
Network
Interface
Link Status
MAC Address
IP Mode
IP Address
Subnet Mask
Gateway
Primary DNS
Secondary DNS
Signal Strength
Network Name(SSID)
Wireless
Link Up
00:26:4D:B4:01:54
Dynamic
192.168.42.131
255.255.255.0
192.168.42.1
202.96.128.166
10.4.4.11
Excellent
TP-Link
Settings
Language
Parental
System
Network
Display
Audio
BD-Live
WIFI Protected Setup (WPS)
Please press the button on your router now
Cancel
DX-WBRDVD1_11-0366_MAN_V3.fm Page 41 Monday, April 18, 2011 12:58 PM
