EFIS Operation
5-14
EFIS-D10A Pilot’s User Guide
•
The UP/DN button toggles the menu and timer between an up timer and a down timer. When switching to an up
timer, the timer set value resets, allowing the up timer to count up from 0:00:00.
•
To reset the timer, press the UP/DN button twice.
•
To start the timer, press START. Once started, the button’s label changes to STOP. To stop the timer, press
STOP.
•
To set the down timer, press HOUR, MIN, and SEC to adjust the timer to the desired value.
•
You may not have an up timer and a down timer running at the same time.
Multiple Dynon products connected via a DSAB network share one timer. Starting, stopping, or configuring the
timer on one instrument causes all other instruments to reflect the change.
OATSET – Setting Temperature Offset
If you did not purchase an EFIS or EMS outside air temperature sensor from Dynon Avionics, you may still manually
adjust the OAT to an approximate value. With this manually entered information, the EFIS-D10A calculates and displays
true airspeed (TAS) and density altitude as it does when an OAT is connected. Ensure that you have indicated that an
EFIS OAT is not installed; enter the EFIS > SETUP > OAT menu and press INSTALLED until the value is “N.”
In the EFIS > OATSET menu, press INC- or DEC+ until the value-setting box above the menu displays the current
outside air temperature. This value is then used in the OAT/TAS/DA info item on the EFIS screen. For more information
on setting up that display, see page 5-12.
Summary of Contents for EFIS-D10A
Page 2: ......
Page 8: ...Table of Contents viii EFIS D10A Pilot s User Guide Appendix D EFIS D10A Specifications 8 8...
Page 34: ......
Page 60: ......