Page | 110
SkyView
HDX System
General Maintenance Manual, Revision F
8.21.3
Installation
1. Connect electrical connectors to control panel.
2. Install control panel in same location on instrument panel using same screws (see
if screws need to be replaced).
3. Restore power to airplane.
4. Turn SkyView system
ON
.
5. Make sure control panel is operational. If not, see Section
8.22
SV-BUTTON-LEVEL Autopilot Level Button
An Autopilot Level (LEVEL) button is an optional button for SkyView HDX Autopilot.
Figure 74: SV-BUTTON-LEVEL
8.22.1
Location
The LEVEL button is typically located on the left instrument panel. For specific location, see the
Equipment Installation Record
document associated with the airplane.
8.22.2
Removal
1. Shut down airplane power.
2. Remove screws that secure button faceplate to instrument panel. Keep screws for re-
installation.
3. Remove button and disconnect electrical connector from button.
