SkyView
HDX System
General Maintenance Manual, Revision F
Page | 115
9 Servicing
The Skyview HDX system does not require special servicing. In the event of system failures,
contact Dynon technical support. Always have a properly rated mechanic or qualified facility
remove a failed component.
9.1
Periodic Maintenance
The Skyview HDX system components are designed to detect internal failures. A thorough self-
test is performed upon application of power to the components, and BITs (Built-In Tests) are
continuously executed. Detected errors are indicated on the SkyView HDX Display. See Section
Troubleshooting
for more information.
Table 12: Period Maintenance
ITEM
DESCRIPTION / PROCEDURE
INTERVAL
2)
Component Removal,
Re-installation, and
Replacement
•
SV-HDX1100 or SV-HDX800 Primary Flight Display
•
SV-HDX1100 or SV-HDX800 Secondary Flight Display
•
SV-ADAHRS 200 ADAHRS
•
SV-OAT-340 OAT Probe
•
SV-MAG-236 Remote Magnetometer
•
SV-GPS-2020 GPS
•
SV-BAT-320 Backup Battery
•
EFIS-D10A Standby Display
•
SV-EMS-220 EMS
•
SV-XPNDR-261 Transponder
•
SV-ADSB-472 ADS-B IN Receiver
•
ADS-B Antenna
•
SV-COM-T25/T8 COM Transceiver
•
SV-COM-PANEL COM Control Panel
•
SV-ARINC-429 ARINC 429 Connection Module
•
AoA Probe
•
Autopilot Servos
•
SV-AP-PANEL, Autopilot Control Panel
•
SV-BUTTON-LEVEL Autopilot Level Button
•
SV-BUTTON-APDISC Autopilot Disconnect Button
•
SV-PANEL-KNOB Knob Control Panel
•
Panel Mount USB Port
3)
On condition, see the
following sections:
•
•
Component Removal
and Installation
Always have a properly
rated mechanic or
qualified facility remove
equipment.
4)
Cleaning the Displays
5)
SkyView HDX Display or EFIS-D10A Standby Display: The front
bezel, keypad, and display can be cleaned with a soft cotton cloth
dampened with clean water. DO NOT use any chemical-based
cleaning agents. Take care to not scratch surface of display.
6)
On condition