Page | 72
SkyView
HDX System
General Maintenance Manual, Revision F
7.15
SV-KNOB-PANEL Knob Control Panel
If the knobs on Knob Control Panel do not control the Barometer (BARO), Altitude (ALT), and
Heading/Track (HDG/TRK) functions on SkyView HDX Display, complete the following:
1. Access electrical connectors on rear of SkyView HDX Display (see Section
).
2. Check lights on rear of panel. The control panel has a LED light to determine its status
as follows:
a. Red light
OFF
: The control panel is not receiving power.
b. Red light
ON
(flashing slowly): The control panel is not connected to SkyView HDX
network but is getting power.
c. Red light
ON
(flashing quickly): The control panel is connected to SkyView HDX
network and is communicating properly.
d. Red light
ON
(not flashing): The control panel has a problem. Contact Dynon technical
support. Always have a properly rated mechanic or qualified facility remove unit.
7.16
Panel Mount USB Port
1. Connect a USB-compatible device to all ports on Panel Mount USB Port to confirm proper
operation.
2. If all ports fail, access rear of SkyView HDX Display (see Section
) and check USB
cable connection from SkyView HDX Display to Panel Mount USB Port.
3. If USB cable connection is good, Panel Mount USB Port has a problem. Contact Dynon
technical support. Always have a properly rated mechanic or qualified facility remove unit.