SV-D700 and SV-D1000 Operation
3-8
SkyView Pilot’s User Guide - Revision M
Table 5–Onscreen Data Allotments
The following diagram illustrates example screen layout configurations.
Figure 6–Example Screen Layout Configurations
Manufacturers that install SkyView into their aircraft can choose to standardize the
screen layouts that are available. When a SkyView system is set up this way, you
may not be able to remove some or all of the pages on a display. Additionally, the
LAYOUT and SWAP buttons may not be available .
Selecting and Arranging Pages on your SkyView Screen
1.
Press SCREEN on the Main Menu.
2.
Press PFD PG, EMS PG, or MAP PG to toggle the display of page on or off.
a.
Alternately, press and hold any of the above buttons for a few seconds to turn
on that page and turn all others off with just one button push.
3.
Press LAYOUT to toggle between different layouts of the pages that are being displayed.
4.
Press BACK to finalize the layout and return to the Main Menu.
Swap Mode
You may, at times, wish to swap the entire screen contents of your left and right displays
without having to select and deselect each page on each display using the above process. This
can be useful for flying from the “other” seat, for use when flight instructing, etc.
Press SCREEN > SWAP on either display to enter swap mode and switch the screen contents of
both displays simultaneously. When your screens are in swap mode, the PFD PAGE, EMS PAGE
MAP PAGE, and LAYOUT buttons are unavailable. Press SWAP again to exit swap mode and
revert to normal display operation.
Note that the SWAP button is only shown on SkyView systems that contain exactly two displays.