![background image](http://html1.mh-extra.com/html/dynon-avionics/skyview-sv-d1000/skyview-sv-d1000_user-manual_2550919027.webp)
SV-D700 and SV-D1000 Operation
SkyView Pilot’s User Guide - Revision M
3-9
Reversion Mode
In multi-display SkyView systems, you can specify a reversion mode that automatically changes
the screen configuration to a specific layout when only one display remains powered on.
For example, if you normally have your left display configured to show PFD and your right
display showing Engine and Map, reversion mode could be configured to show all three pages
automatically on the single remaining display, should the other fail.
If reversion mode is enabled, any one of the following layouts can be pre-configured (via
SkyView setup procedures) to be displayed when only one display remains powered on in a
multi-display system. This behavior applies equally whether all but one display in your system
has failed, or if you turn on one SkyView display before all others (as some customers do to see
engine instruments before engine start):
PFD 40% / EMS / MAP 40%
PFD 50% / MAP 50%
PFD 50% / EMS 50%
PFD 80% / EMS 20%
PFD 100%
See the SkyView Installation Guide for further information about Reversion Mode
configuration.