SkyView
HDX System Configuration Manual; Beechcraft Bonanza P35 - V35B, Revision A
Page | 3
3
Configuring SkyView HDX using the Setup Menu System
The following is an overview of each of the system configuration menus, their sub-menus, and
the information that must be selected or inputted to match the certificated configuration.
3.1 SETUP Menu Entry
The SkyView HDX Display features a row of eight buttons across the bottom below the screen.
These buttons are numbered 1-8 from left to right. Simultaneously pressing and holding buttons
7 and 8 will open one of the setup menus. There are two setup menus: The
Setup Menu
and the
In-Flight Setup Menu
. If the airspeed is zero, the Setup Menu will open. If the airspeed is greater
than zero, the In-Flight Setup Menu will open.
You may also access the Setup Menu from the In-Flight Setup Menu by using the ENTER FULL
SCREEN SETUP MENU option.
3.2 SETUP Menu
The setup menu provides access to the following system configuration menus:
•
SYSTEM SOFTWARE
•
SYSTEM SETUP
•
LOCAL DISPLAY SETUP
•
PFD SETUP
•
EMS SETUP
•
MAP SETUP
•
AUTOPILOT SETUP
•
TRANSPONDER SETUP
•
TRAFFIC SETUP
•
ADS-B STATUS
•
COM RADIO SETUP
•
HARDWARE CALIBRATION
When a setting within one of the setup menus or sub-menus are changed in a SkyView display,
the change is synchronized to other SkyView displays, when installed. It is not necessary to
make the change in every display.
3.2.1 System Setup Menu Configuration
The System Setup menu contains menus and pages related to the entire SkyView system. The
following list of menus can be found in System Setup:
•
SKYVIEW NETWORK SETUP
•
WI-FI SETUP
•
SERIAL PORT SETUP
•
AUDIO SETUP
•
AIRCRAFT INFORMATION
•
MEASUREMENT UNITS
•
TIME
•
ARINC-429
•
SCREEN LAYOUT SETUP
•
PRIMARY COM
•
DISPLAY COM IN TOP BAR
•
DATA LOG SETUP
Summary of Contents for SkyView HDX System
Page 2: ......
