Page | 10
SkyView
HDX System Configuration Manual; Beechcraft Bonanza P35 - V35B, Revision A
Enter this page to configure displayed units (e.g., feet or meters). Configure the Measurement
Units as desired.
3.2.8 Time Menu
First, configure the Top Bar to display time in SETUP MENU > LOCAL DISPLAY SETUP >
TOP BAR SETUP > TIME: and choose either ZULU or LOCAL time.
Return to the SYSTEM SETUP > TIME menu and adjust your preferred offset from the time
currently displayed on the Top Bar.
3.2.9 ARINC-429 Menu
This menu configures the SV-ARINC-429 module, if installed. The SV-ARINC-429 provides an
interface through which an external IFR Navigator can communicate with SkyView. An SV-
ARINC-429 module must be configured in the SkyView network for this menu item to become
enabled.
3.2.10 Screen Layout Setup Menu
Enter this page to configure the availability of the PDF Page, Engine Page, and Map Page on
this display and throughout the system (when more than one display is installed). Configure
the settings according to
Figure 7 SCREEN LAYOUT SETUP Configuration
3.2.11 Primary COM Menu
Select the desired COM radio to be displayed on the Top Bar and receive a frequency setting
when the APT→COM button is pushed in the MAP MENU. If only one COM radio is installed,
this must be set. If two COM radios are installed, only one can be displayed on the Top Bar and
receive a frequency setting when the APT→COM button is pushed in the MAP MENU.
Summary of Contents for SkyView HDX System
Page 2: ......