EN
LR-140
7
PowER SUPPLy
The device is powered by two 1.5V AA (LR6) batteries. Do not use rechargeable batteries.
Inserting the batteries
1. Gently press the indentations on the side of the battery compartment lid, then pull the lid down.
2. Insert two 1.5V AA batteries into the battery compartment, taking care to ensure the + and - symbols on the
batteries correspond with the markings on the compartment. Inserting batteries incorrectly may damage the
device.
• The batteries should be replaced when the device will not switch on or when the motor sounds as though it’s
slowing down.
• Leaking batteries may damage the device. This type of damage is not covered by the manufacturer’s
warranty. To avoid causing any damage:
• Always insert the batteries correctly, taking care to ensure the + and - symbols correspond with the markings
on the compartment.
• Replace discharged ‘flat’ batteries immediately with new ones.
• Always remove the batteries if the device won’t be used for a while.
For the sake of environmental protection, you are kindly requested not to put used low batteries
into the household waste but to dispose of them in the container of an authorised dealer.
USINg of aPPLIaNCE
• Unpack the appliance and remove all the packing materials.
• Examine the device to make sure it’s complete and has not suffered any damage. You should only use the
device if all parts are present and undamaged.
• Set the appropriate cutting length according to the type and fluffiness of the material. Turning the
adjustment to the left will cause less material to be removed, turning it to the right will remove more lint for
a closer shave. If you’re not sure which setting to use, start by turning the control to the left and then change
the cutting length if necessary.
Summary of Contents for LR-140
Page 1: ...1 3 4 2 7 6 3 5 1...
