Dear Customer,
All electrical and mechanical equipment needs to be cared for appropriately. It’s important
to note that using or storing the device in certain conditions may adversely affect its lifespan
and functionality. Always protect the device from the conditions listed below.
Using or storing the device in a wet, humid or damp environment can cause:
- deterioration and premature aging of the cover and electric insulation of the device,
- premature wearing and aging of the plastic and rubber components,
- rust and corrosion affecting electrical components and metal parts.
Using the appliance in a dusty environment or in the kitchen (where the air may be contaminated
with vapors from cooking oil or grease) can cause greasy dust coatings on the mechanical and
electrical elements and the casing of the appliance, which could result in electrical contact failure or
even complete breakdown, and could also damage the plastic and rubber elements.
Direct sunshine can cause:
- premature aging of the device,
- deterioration of the plastic and rubber parts, resulting in a risk to the user’s safety.
Storing the device in a frosty or cold environment can cause:
- plastic and rubber parts to become fragile, resulting in a risk to the user’s safety,
- rust and corrosion affecting electrical components and metal parts.
Direct and indirect heat (e.g. being too close to an oven or a heating appliance) can cause:
- damage, deformation, softening or melting of plastic and rubber parts
- deterioration of electrical insulation, resulting in a risk to the user’s safety.
Please avoid the following situations as they may reduce the life and adhesion of the massage pads:
- using or storing the equipment in a wet or damp environment; using or storing the equipment
in a kitchen; exposing the equipment to radiating heat or direct sunshine; storing the product in
an extremely cold place; failing to replace the protective foil on the massage pads after use.
Following the operating instructions and avoiding any of the conditions listed above will help you
increase the lifespan of the device. The manufacturer is not responsible if the device is stored
inappropriately or contrary to these instructions. You are recommended to have the device serviced
regularly by an authorised engineer to keep it working for as long as possible.
•
If your device is damaged or operates in an abnormal way, immediately stop using it and take it to an
authorised service engineer for checking, repair or adjustment.
•
The manufacturer is not responsible for any damage that results from overuse, incorrect operation,
incorrect maintenance, neglecting the information given in the instruction manual or normal wear
and tear. In addition, the manufacturer is not responsible for damage caused by any parts of the device
breaking or cracking.
MSL-7525
8
•
Do not immerse the device in water or any other liquid! If humidity gets into the device, it can cause defects,
so do not use it in the bathroom or any other room where there is high humidity.
•
Attention! Should the device, despite your caution, fall into water or make contact with humidity in any
other way, please take it to the authorised service station and have it checked by an expert before re-using it!
We have to call your attention to the fact that if the product becomes defective due to environmental effects
like this, it will be considered as improper handling, and the manufacturer's warranty will lapse!
•
If you do not use the device for a longer period of time (more than 1 month) then please remove the batteries
from the battery holder. If you do not do this, corrosive chemicals may escape from the batteries and damage
the device.
•
Attention! The device must not be disassembled, its casing must not be removed, or its repair attempted.
There are no parts inside the device that could be home repaired or used for any other purpose. In the
case of any defect of the device please have it repaired only by an authorised special service station. The
manufacturer does not undertake any warranty for any improper attempt at repair, or any intervention
performed by unauthorised persons.
•
Important! The massager must only be used with the massage pads and wires supplied in the box. You
must not shorten or extend the wires, carry out any other modification or use any additional parts that
are not recommended by the manufacturer. Doing this may cause an accident or other problems with the
device. If the device is damaged or operates in an abnormal way, immediately stop using it and take it
to an authorised service engineer for checking, repair or adjustment.
Keep your environment clean! After use the device cannot be disposed together with solid
residential waste, because it can seriously damage living beings and human health. Please hand
over the device - at the end of its lifetime - to a waste disposal facility specializing in collecting
electrical devices, or to a waste disposal facility performing recycling or environmental friendly
disposal of electrical devices. In addition please never put spent batteries removed from the
device in the household waste, but take them to a collecting point designated for this purpose,
because spent batteries are hazardous waste, they contaminate the environment if they are not
disposed of, collected or destroyed in an environmentally friendly way.
•
The device can be energised only by batteries. Neither a mains connection, supply adapter nor supply
accumulator can be used for its power supply.
•
Please use only batteries as specified in the instruction manual. Other batteries (other size or shape) cannot
be inserted in the device and it may become inoperable or damaged when used with batteries supplying a
different voltage.
•
Please always replace all the batteries at the same time and by the same type.
•
Never dispose of the replaced batteries in the household waste, because they will endanger the
environment! Please use a dedicated waste container provided for this purpose or a collecting station for
disposing of used batteries!
EN
MSL-7525
9
User'sManual MSL-7525:User's Manual for MSL-7525 2010.05.12. 9:50 Page 8
