Dytran Instruments, Inc. 21592 Marilla St. Chatsworth, CA 91311 Phone: (818) 700-7818 Website:
email: info@dytran.com
Page | 11
Figure 11: TSA analysis results for one period
7.7
“FFT ANALYSIS” button will perform Fast Fourier transform.
7.8
“PLOT VERTICAL UNIT” for use with 4400B only. Output units defined by user configuration.
7.9
“RPM” control requires user input for TSA calculations and cursor location.
7.10
“PLOT HORIZONTAL UNITS” allows the change between Hertz, Orders, and RPM for FFT plots.
7.11
“GET RMS” button shall show the RMS signal value for each channel.
8.
“DATA EXPORT” tab allows the export of the data to conventional file formats:
.csv
,
.mat
,
.tdms
,
.uff
,
and
.sqlite
8.1
User shall define the location of the file on the PC using the explorer.
8.2
If “EXPORT ALL RAW DATA” is checked, the software will export all the raw data from the
measurements file. If the “EXPORT ALL RAW DATA” is not checked, the software will export only
the content of the analysis screen.
VII.
Mechanical configuration and mounting
1.
Refer to 127-4600A1 drawing for physical dimensions of the device.
2.
The mounting provisions consist of 2 mounting holes, 0.20” in diameter. Two 10-32 socket head screws
are supplied with the device. In order to mount the device, reference mounting considerations located
on the 127-4600A1 outline/installation drawing.
3.
Alternative method of mounting is four magnets embedded into the mounting surface of the
VibraCorder.