Step 3:
Within the next 5 seconds, press the appropriate function button on the transmitter 2
x and LED 7 flashes. Press briefly to the store button P and LED 3 now lights up.
The operation can be repeated any number of times. With transmitters of this series that have
more than one channel, another garage door can be opened on each channel if required.
9.2 Changing the battery of the radio transmitters (all models)
Warning:
Use only the same battery types with the same data.
Step 1:
Loosen screws at the rear of the transmitter and remove the cover.
Step 2:
Replace battery, ensure correct polarity (+/-).
Step 3:
Attach the cover and tighten the screws.
9.3 Programming keypad transmitter for wall installation (optional accessories)
9.3.1 Instruction
• This is a 2-channel transmitter, which is activated only by an individual number (PIN).
• The devices are suitable for installation in indoor and outdoor areas.
• High reliability thanks to "rolling radio code" changes with each dial-in
• The transmission range is approx. 200 m outdoors and 35 m indoors.
9.3.2 Installation location
The installation location should have the smallest possible distance to the drive (receiver).
With reduced battery capacity the transmitter distance is also reduced. Metal mesh and metal
shelving can interfere with the radio signal between transmitter and receiver as well as
reinforced concrete walls and ceilings. Exclude such sources of interference during
installation. Thanks to the device protection class IP 54 the keypad transmitter can be
installed, if necessary, in the open air.
Acoustic signal
M e a n i n g
1 short beep
1 long beep
3 long beeps
10 fast beeps
5 short beeps
Key beep
Automatic switch-off
Change of combination confirmed
Error when entering the combination
low battery
30
