INSTALLATION AND CONNECTION
The ceiling speakers must be fitted only after a survey has been conducted as described above, the
provided cut-out template and appropriate tools should be used to install the speakers.
1.
Mark the location of the cutout using the template provided
2.
Cut out the hole for the speaker to be fitted
3.
Connect speaker cables to the + and – terminals on the active speaker with the Bluetooth module
(Figure 1), make sure to observe the correct polarity
4.
Route these cables as required through the cut-out hole and connect to the passive speaker
(Figure 2), again, make sure to observe the correct polarity
5.
Route the power supply cable as required through the cut-out hole and connect to the active
speaker (Figure 3)
6.
Tidy the cables in the cut-outs so the speaker can be fitted
7.
Push the speaker into the hole and tighten the screws using a Philips head screwdriver
8.
Clip the front plate onto the speaker
Figure 3
Figure 2
Figure 2
