32
KH 2370
33
KH 2370
If folders exist:
With this function you can select certain files in the current
sub-folder for programmed playback. You can determine
the order in which the files are played back.
To operate the programmed playback function, go to the
corresponding chapter and continue reading.
SINGLE
The currently selected file is played back once.
REP-ONE
The currently selected file is played back repeatedly. The
repeat playback is continued until you stop the playback
by pressing the STOP button.
Selecting playback mode
1
If a file is being played back, first of all stop the play-
back with the STOP button.
2
Change from the list of the files to the mode selection
bar with the right control button. Firstly the FOLDER
playback mode is selected automatically.
3
You switch through the different playback modes with
the up and down control buttons.
4
If the required playback mode is displayed, then exit
the mode selection bar with the left control button.
The marking is now in the list of the files of the select-
ed sub-folder again.
5
To start the playback in the set mode, press the PLAY
button. The playback starts with the marked file in the
list of files.
Programmed playback (Program)
If you have selected the PROGRAM PO mode, to select sev-
eral files for programmed playback:
1
Change back to the list of the files of the current sub-
folder using the control buttons.
2
Select the first file to be programmed using the control
buttons.
Note:
If folders exist: You can only select files for programmed
playback from the currently selected sub-folder. Files
from different sub-folders can not be selected for pro-
grammed playback.
3
Confirm the selection by pressing on the ENTER button
on the remote control. The selected file is now dis-
played as the first programmed file on the top of the
SMART NAVI menu,.
Example:
If you have programmed the fifth file (in the
current sub-folder), then Program 01:0005 is displayed.
4
Repeat steps 1 and 2, until all required files have been
programmed.
5
Then press the STOP button. PROG-END is displayed in
the mode selection bar.
6
Press the PLAY button to start the playback of the pro-
grammed files.
7
To delete the programmed playback, change to anoth-
er playback mode.
Cleaning the
combination unit
Clean the casing of the combination unit only with a
slightly damp cloth and a mild detergent. Pay attention
that no moisture enters into the combination unit!
Clean the inside of the disc tray – if necessary – only with a
clean dry brush (e. g. lens brush, can be bought in special-
ised camera shops). Never clean the inside of the disc tray
with a wet cloth!
Warning!
If moisture penetrates into the combination unit, there
is a risk of getting an electric shock! In addition this can
cause irreparable damage to the combination unit!
To rectify malfunctions
and errors
Nothing appears on the display/
combination unit shows no function,
although it is switched on
A
Check whether the power cord has been plugged into
the power socket properly.
B
Check whether the power socket, in which you have
plugged the power cord of the combination unit, has
electric current, by connecting another device to the
power socket. If necessary, plug in the power cord of
the combination unit into another power socket.
