Manual for Power Pack compatible for Yamaha* PW Series drive system
* Yamaha is a trademark of the YAMAHA CORPORATION
Page
9
of
12
Battery usage
Your power pack automatically goes into so-called deep sleep mode after approx. 14
days to keep self-discharge as low as possible. Before the next use (charging or using
the pedelec), the battery must be awakened from deep sleep by pressing the button on
the battery. Waking up is symbolized by turning on the LEDs in sequence.
The drive system is also switched off (by the battery) after approx. 5 minutes if the
Pedelec is not used. It is irrelevant whether the light of your pedelec is activated or
not!
When inserting the battery, make sure that it is correctly positioned before you snap it
into the lock. Otherwise the battery case may be damaged!
Do not press the capacity button several times in quick succession, otherwise you will
immediately activate and deactivate the battery again.
Have you correctly installed your new E-Bike Vision Power Pack in your pedelec and locked
it with the lock (don't forget to remove the key!)? Then switch on the drive system using the
on / off switch on your display. The drive system now reads the current capacity from the
battery and your motor will calculate the approximate remaining range based on your
previous driving profile. The battery has no influence on the range calculation of the drive
system.
Do not remove the battery from the pedelec while the drive system is activated. Switch
this off beforehand!
