54
Rev. 0.7
info@e-breathe.de • www.e-breathe.de
55
Rev. 0.7
e-breathe e-Flow
info@e-breathe.de • www.e-breathe.de
e-breathe e-Flow
6.2 Cleaning and Disinfection
Important: Care must be taken during the work steps, otherwise there may be damage to the components. For
this reason, only use the procedures described. Other procedures or cleaning agents could damage components.
Important: Do not use solvents (e.g. acetone, turpentine) or bleaching agents (perborate, percarbonate), hot
water, compressed air or pressurized water for cleaning.
6.2.1 Disassembly of the device:
Disconnect the breathing hose, breathing connection, filter, carrying system/belt, battery and all accessories from
the blower.
6.2.2 Clean the breathing hose, breathing connection and all accessories according to the enclosed instructions for
use.
Important: Make sure that no liquid enters the blower during cleaning and disinfection and no liquid comes into
contact with the battery contacts.
6.2.3 Cleaning of the carrying system and blower unit
Commercially available detergent can be used for daily care. Dilute detergent with lukewarm water and wipe off the
parts to be cleaned with a cloth. Heavy stains can be carefully removed with a soft brush. Then wipe the individual
parts dry with a cloth and leave to dry by air. Protect from direct sunlight.
6.2.3 Disinfection of the carrying system and blower unit
The following disinfectants are recommended: PM Desk or Curacid PSA Ultra.
Dilute disinfectant with lukewarm water (mixing ratio see bottle imprint) and wipe off the parts to be cleaned with
a cloth. Heavy stains can be carefully removed with a soft brush. Then wipe the individual parts dry with a cloth and
leave to dry by air. Protect from direct sunlight.
7.0 Storage
Clean the blower before storing it. Remove the filters and battery. Charge the battery before storage, and recharge the
battery in the meantime if stored for a longer period. After cleaning, store the equipment in a dry and clean place away
from direct heat and sunlight. The blower should be stored in a closed container or cabinet, away from dust, light,
chemical vapors and heat sources. A properly stored, unused blower will function even after a long period of storage.
8.0 Labelling / Explanation of Symbols
See page 137
for illustrations of the respective nameplate (blower unit, battery and charging station).
9.0 Certification Authority
Nr. Description
1
Product Description
2
Part. No
3
Approved Standards
4
Country of production
5
Manufa Address
6
Serial Number
7
Date of manufacture / fabrication number
8
QR-Code / Barcode
9
Symbol observe instructions for use
10
Symbol CE Marking
11
Symbol Recycling
12
Symbol Disposal
13
Symbol Temperature and Humidity
14
Battery Warning Label
15
Warning Label Charging Station
0°C
+30°C
< 70%
The following storage temperatures should best be
maintained for the complete blower unit.
8.1 Marking blower unit, battery and charging station
8.2 Labelling Packaging
You will find the following labelling information on the packaging:
- Product Description
- Serial number
- Symbol observe instructions for use
- Part. No
- Date of manufacture
- symbol CE marking
- Approved Standards
- Manufacturing number
- Symbol temperature and humidity
- Manufa Address
- QR-Code/Barcode
Institut für Arbeitsschutz der
DGUV - IFA -
Alte Heerstraße 111
53757 Sankt Augustin - Germany
Kenn-Nr.: 0121
Polski Rejestr Statkow S.A.
Aleja General Jozef Haller 126
80-416 Gdansk - Polen
Kenn-Nr.: 1463
