Rev. 4.0
11
info@e-breathe.de • www.e-breathe.de
e-breathe Smartblower
a) Prüfen Sie, dass der Schlauch keine Risse oder Löcher hat und vollständig intakt ist. Überprüfen Sie auch die Dich-
tungen in den Anschlüssen des Schlauches. Sollte der Schlauch nicht vollständig intakt sein, darf dieser nicht verwen-
det werden.
b) Schrauben Sie den Rundgewindeanschluss des Atemluftschlauches im Uhrzeigersinn auf die gelbe Überwurfmut-
ter der Motor-Einheit. Achten Sie dabei darauf, dass sich der Schlauch nicht verdreht.
c) Kontrollieren Sie, ob der Atemluftschlauch sicher und fest mit der Motor-Einheit verbunden ist, sodass keine Um-
gebungsluft eindringen kann.
d) Um den Atemluftschlauch zu demontieren, müssen Sie den Rundgewindeanschluss gegen den Uhrzeigersinn von
der gelben Überwurfmutter abdrehen.
4.2.3.3 Atemschlauch Montage / Wechsel
Lesen Sie die dem Kopfteil beiliegende Gebrauchsanleitung sorgfältig durch.
!
b)
Montage Y-Connector & zwei Partikelfilter
Der Y-Connector ist ein Adapter, der konzipiert wurde, um zwei Partikelfilter mit dem e-breathe Smartblower-System
zu verwenden. Dies ist vor allem dann sinnvoll, wenn eine Erhöhung des Luftvolumens und eine Verlängerung der
Standzeit notwendig ist.
Schrauben Sie nacheinander, rechts und links, die beiden Partikelfilter im Uhrzeigersinn handfest in den Y-Connector.
Abb. 13
Demontage Y-Connector & zwei Partikelfilter
Zur Demontage schrauben Sie nacheinander, rechts und links, die beiden Partikelfilter gegen den Uhrzeigersinn aus
dem Y-Connector raus.
c) Montage Y-Connector & Motor-Einheit
Die Motor-Einheit saugt durch den Y-Connector und die daran befestigten Partikelfilter von außen die Luft an und
leitet diese gefiltert an das Kopfteil weiter.
Setzen Sie die Motor-Einheit mit der Ausrichtung des Verbindungskabels nach rechts auf die gelbe Überwurfmutter
des Y-Connectors. Halten Sie die Motor-Einheit fest, damit sich das Verbindungskabel nicht verdreht und schrauben
Sie die gelbe Überwurfmutter des Y-Conncetors im Uhrzeigersinn handfest in das Innengewinde der Motor-Einheit.
Abb. 14
Demontage Y-Connector & Motor-Einheit
Halten Sie die Motor-Einheit fest und drehen Sie die gelbe Überwurfmutter des Y-Conncetors gegen den Uhrzeiger-
sinn von der Motor-Einheit ab.
d) Montage Smartbelt & SVE
Der Smartbelt verfügt über eine Schlaufe, die zur Anbringung der SVE dient. Stecken Sie den Clip an der SVE durch die
Schlaufe, sodass die SVE sicher am Smartbelt sitzt.
Abb. 15
Demontage Smartbelt & SVE
Um die SVE vom Smartbelt zu entfernen, ziehen Sie die SVE aus der Schlaufe heraus.