18
AUTOMATIC SHUTDOWN
Your Quattrolete scooter is equipped with an energy saving system. The Quattrolete has a timer that in case of leaving the ignition key in its ignition
position (“ON”) for more than 20 minutes without circulating the scooter turns off.
If you wish to resume circulation you must perform the following operations:
1. Remove the key from the bowler hat.
2. Reinsert the key and turn to restart the scooter.
COMFORT SETTINGS
ADJUSTMENT OF THE ANGLE OF THE HANDLEBAR
DANGER.
Remove the key from the bowler before adjusting the handlebar. Never try to adjust the seat or handlebar while moving.
Your Scooter is equipped with an adjustable handlebar at its base to zoom in or away from the passenger.
1. While holding the scooter, rotate counter-clockwise the knob at the base of the handlebar to loosen.
2. Move the handlebars to a position where the driver can access and drive comfortably from the seat.
3. Turn the handlebar knob clockwise to secure it in position.
To fully fold the handlebars for transport or storage, you must first remove the battery and then
completely disassemble the seat.
ADJUSTMENT OF SEAT ROTATION AND FEED
The seat rotation control is on the right side under the seat. This control block in different positions of the axis of
rotation the seat.
1. Pull up the rotation control of the seat to release the axle.
2. Rotate the seat to the desired position without releasing the control.
3. Release the control to secure the seat. The end of the control must be wedged between the axle teeth.
4. Press the front lever under the seat to bring it closer or separate it from the handlebars.
ADJUSTMENT OF THE SPACE BETWEEN ARMRESTS
The arms can be adjusted towards the inside of the seat or towards the outside to allow a support adapted to the driver.
1. Loosen the armrest adjustment knobs on each side of the seat.
