FOR POOLS THAT SHUT DOWN IN THE WINTER
PROCEDURE 2
: -
1.
Back-Wash and rinse filters.
2.
Switch Unit to
IONIZATION
. Run 24/7 non-stop and check Copper level. Run Unit until you
achieve a reading of 1ppm.
3.
Shut down the pool.
Switch Unit OFF
.
4.
START-UP
procedure beginning of new season: -
Unit should be OFF
Set
BYPASS
valves
to BYPASS the eClear system.
5.
Back-Wash and rinse filters thoroughly.
6.
Adjust pH to between 6.8ppm and 7.2ppm with the Multi-Valve set to CIRCULATION.
7.
Set Multi-Valve to FILTRATION. Add
ACTIVE OXYGEN
to
shock
pool water
-
(see product
label for instructions) Add directly into the skimmer.
8.
Place a natural Non Metallic Floc cube into the pump Pre-Filter. (
Action Cube
recommended).
9.
Add a Non-Metallic Algaecide through the skimmer (See recommended dosage on the
container) normally at 1 Litre per 40m3
10.
Run pump on FILTRATION 24/7 Non-Stop until clear. Back-Wash filters every 24 Hours!
11.
When water is clear.
Set
BYPASS
Valves
to flow through the eClear.
12.
Switch Unit ON
. Now begin at number
7
of PROCEDURE
1
.
WARNING FOR INSTALLATION IN OLD POOLS
PROCEDURE 3
: -
After a few days of use, considering the water was crystal clear, your pool may then become
cloudy! The natural
OXYGEN
process will begin to detoxify your pool walls and pipe-work. It will
begin to leach out the Calcium.
NOTE!!! It could take as long as 2 weeks to finally obtain clear consistent water.
REMEDY:-
This is a short term and initial set up problem meaning that you did not confirm
your pool shell and filtration system with us prior to installation for full advice! If
your tiled pool has sound grouting, the filter sand is new and the pipes have been
cleaned then your pool is being detoxified. The natural Oxygen process is leaching
out calcium from your pool walls, floor and pipe work (if they were not cleaned). It
will give your pool a new lease of life. You will need some Active Oxygen shock
treatment and a non metallic flocculent cube (Action Cube) to be placed into the
pump pre-filter. Run the pump 24/7 non stop until clear, back washing the filters
every 24 hours until your water is perfect. Normally, 3 or 4 days. This may reoccur
2 or 3 times in old pools. Just repeat the process. This process is doing the world
of good for your pool water that has been abused by Toxic chemicals for years.
WHEN USING WELL WATER
PROCEDURE 4
: -
Regardless if the water looks clear!
Unit OFF!
1.
Set
BYPASS
valves to BYPASS the eClear system.
2.
Adjust pH to 7.2ppm
3.
Use Metal – Iron remover. Normally 3Lt per 100m3 but read instructions on the
product. Mix in a bucket of water first and put into the skimmer. Circulate on
FILTRATION.
4.
Add an Action Cube or non metallic filter flocculent into the pump pre-filter.
5.
Run pump Non-Stop 24/7 and Back-Wash filter every 24 Hours.
6.
Go to number
3
of
PROCEDURE 1.
