PROCEDURE 5
: -
If the water is very murky!
Unit OFF!
1.
Set
BYPASS Valves
to BYPASS the eClear system.
2.
Adjust pH to 7.4ppm – 7.6ppm
3.
Switch PUMP OFF
.
4.
You will need a surface level flocculent (
Alum Powder or liquid
)
5.
Sprinkle the floc all over the surface of the pool and leave over night.
6.
SWITCH PUMP ON.
Vacuum all debris to waste and not through the filter.
7.
Repeat above points 2 to 4 if still not clear.
8.
When clear go to number
3
of
PROCEDURE 1
.
MARBLE AND VINYL - NEW POOLS - Unit OFF!
PROCEDURE 6
: -
New Marble pools need to be de-gassed and plaster/cement dust removed. Vinyl pools
need to be de-gassed. The procedure is the same. The process is best over a 3 week
period. This is to the benefit of the owner!
1.
Back-Wash and Rinse filters thoroughly.
2.
Adjust pH to 6.8ppm – 7.2ppm (
Always Pre-Mix
pH correction chemicals in water
and enter into skimmer with eClear on
Bypass and switched OFF
)
3.
Use house-hold bleach at 4 Litres per 50m3 and per week.
4.
Add a Non-Metallic Algaecide through the skimmer at 1 Litre per 40m3 each week for
3 weeks.
5.
Add 1 Action Cube or Non Metallic filter flocculent in to the pump Pre-Filter. Replace
when used.
6.
Back-Wash and rinse filters after 24 Hours then once each week.
7.
After 3 weeks, go to number
3
of
PROCEDURE 1.
NOTE
: If you continue to use Chlorine then the procedure will take another week. So 4
weeks of degassing and plaster dust removal.
IMPORTANT
: - If a Marble pool. After the degassing and cleaning period, remove the filter
top, and remove any debris. Mix well the top sand. If necessary, replace the sand. Back-wash
for 5 minutes and then rinse for 3 minutes.
F.A.Q.
Algae Problems
: -
Copper residual below 0.5ppm Raise this to 0.7ppm but first shock
treat with ACTIVE OXYGEN and Non metal Algaecide.
Good Maintenance
: - It is a good idea to clean your electrodes once each year. Remove
Cell and mix 1 part acid to 2 parts water.
Pass the liquid several times through the Cells in a bucket.
