Document:
Date
Created By:
ECO#
LPN00662X0001A0_A
9-16-2019
TMT
011012
INSTALLATION INSTRUCTIONS
E-WFS Series
www.e-conolight.com | 888.243.9445 | FAX: 262.504.5409
CAUTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety
precautions should always be followed including the
following:
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
1. DANGER
- Risk of shock- Disconnect power before
installation.
DANGER
– Risque de choc – Couper l’alimentation
avant l’installation.
2. This luminaire must be installed in accordance with the
NEC or your local electrical code. If you are not familiar
with these codes and requirements, consult a qualified
electrician.
Ce produit doit être installé conformément à NEC ou votre
code électrique local. Si vous n’êtes pas familier avec ces
codes et ces exigences, veuillez contacter un électricien
qualifié.
3. Suitable for Wet Locations.
Adspte pour les Endroits Mouiles.
4. WALL MOUNT ONLY.
INSTALLATION MURALE SEULEMENT
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE
1.
Remove the quick mount bracket from the fixture base by
loosening the two set screws. See
Figure 1.
2.
Install the quick mount bracket on a junction box at the intended
location using hardware supplied with junction box. Make sure
arrow on the bracket is pointing up. A high grade caulking
material, such as silicone rubber, should be used between gasket
on bracket and mounting surface.
NOTE:
The bubble level on the quick mount bracket can be used
to ensure the bracket is mounted level.
3. Pull supply leads through center hole in quick mount bracket.
4.
Attach the aircraft cable hook from the fixture base to the center
hole in the quick mount bracket to support the fixture.
5. Make wiring connections per the
Electrical Connections
section.
6.
While holding fixture, remove aircraft cable from the fixture base
by removing screw holding cable in place. Discard cable and hook.
7.
Attach fixture base to the quick mount bracket by hooking top
of bracket into the angled bracket on the back side of the fixture
base. Next, lower the fixture until base sits flush with mounting
surface.
8.
Secure the fixture base to the quick mount bracket by tightening
two set screws on bottom of the fixture base.
9. Apply a high grade caulking material, such as a silicone rubber,
between the fixture base and the mounting surface. Make sure
caulking material is also applied at the set screw locations.
1.
Remove the quick mount bracket from the fixture base by
loosening the two set screws. See
Figure 1.
Properly discard the
quick mount bracket.
2.
For attachment of box to mounting surface, drill (2) 9/32" (8mm)
holes in opposite corners on the back surface of the surface
mounting box accessory (E-ACSBWFZ) for use with 1/4” (7mm)
fasteners. Do NOT drill holes within 1/4” (7mm) of the edge on the
surface mounting box
3.
Attach surface mounting box to mounting surface using 1/4”
(7mm) fasteners appropriate for mounting surface. Angled side of
surface mounting box must be positioned facing up and down (on
vertical axis of box). See
Figure 2 on back page.
NOTE:
A high grade caulking material, such as a silicone rubber,
should be used around perimeter of mounting box between back
surface of box and the mounting surface to ensure a watertight
enclosure.
MOUNTING OVER JUNCTION BOX
FIGURE 1
Fixture Base
Quick Mount
Bracket
Set Screws
MOUNTING USING SURFACE CONDUIT (REQUIRES
USE OF E-ACSBWFZ ACCESSORY)
