11
User Manual EE072 Humidity and Temperature Probe with Modbus RTU
6.4 Repairs
Repairs may be carried out by the manufacturer only. The attempt of unauthorized repair excludes any
warranty claims.
6.5 Configuration Interface
The EE072 is ready to use and does not require any configuration by the user. The user can change
the factory setup by using the Modbus configuration adapter (order code HA011018) and the EE-PCS
Product Configuration Software.
One can change the digital communication settings, perform a RH and T adjustment in the form of an
offset or as a 2-point adjustment and set the air pressure at the operating point.
EE-PCS PRODUCT CONFIGURATION SOFTWARE
1. Download the EE-PCS Product Configuration Software from
install it on the PC.
2. Connect the E+E device to the PC using the appropriate configuration cable.
3. Start the EE-PCS software.
4. Follow the instructions on the EE-PCS opening page for scanning the ports and identifying the
connected device.
5. Click on the desired setup or adjustment mode from the main EE-PCS menu on the left and follow
the online instructions of the EE-PCS.
PC
HA011018
6.6 RH / T Adjustment and Calibration
Definition
• Adjustment
the specimen is brought in line with the reference.
• Calibration
the specimen is compared with a reference and its deviation from the reference is documented.
Humidity calibration and adjustment
Depending on the application and the requirements of certain industries, there might arise the need for
periodical humidity calibration (comparison with a reference) or adjustment (bringing the device in line
with a reference).
Calibration and adjustment at E+E Elektronik
Calibration and/or adjustment can be performed in the E+E Elektronik calibration laboratory. For
information on the E+E capabilities in ISO or accredited calibration please see
www.eplusecal.com
.
Calibration and adjustment by the user
Depending on the level of accuracy required, the humidity reference can be:
• Humidity calibrator (e.g. Humor 20), please see
www.epluse.com/humor20
.
• Handheld device (e.g. Omniport 30), please see
www.epluse.com/omniport30
.
• Humidity standards (e.g. Humidity Calibration Kit), please see
www.epluse.com/EE072
.
