14
GENERAL
The manual is a part of the scope of supply and serves to ensure proper handling and
optimum functioning of the instrument. For this reason, the manual must be read
before start-up.
In addition, the manual is for all personnel who require knowledge concerning transport,
setup, operation, maintenance and repair.
The manual must not be used for the purpose of competition without a written consent
from E+E Elektronik
®
and must also not be forwarded to third parties.
Copies for personal use are permitted.
All information, technical data and illustrations contained in these instructions are based
on information available at the time of publication.
Symbol assertion
This symbol indicates a safety instruction.
These safety instructions should always be followed carefully.
By not following these instructions injuries of persons or material damage could happen.
Therefore E+E Elektronik
®
does not accept liability.
This symbol indicates a note.
These notes should be followed to achieve optimum functioning of the equipment.
General safety instructions
•
Extreme mechanical stress and improper use must be avoided.
•
Be careful when removing the filter cap to avoid damage of the sensor element.
•
The sensor is an Electro Static Discharge sensitive component (ESD). When
touching the sensor element, ESD protective measures should be followed.
•
Hold the sensor on the connection wires only.
•
Installation, electrical connection, maintenance and start-up procedures should be
executed by qualified technical personel only.
Safety instructions for using the alarm output module with voltages >50V
•
For the separation of the alarm output module from the connecting terminals the the
refor designated partition must be mounted in the bottom.
•
During operation the housing of transmitter must be closed.
•
Work on live parts is to be omitted basically and may only be executed by trained
personnel. The protection class of the opened housing is IP00. Components with
dangerous voltages can be touched directly.
Safety instructions for use of the integrated power supply (option V01)
•
During operation the housing of transmitter must be closed.
•
Work on live parts is to be omitted basically and may only be executed by trained
personnel. The protection class of the opened housing is IP00.
Environmental aspects
Equipment from E+E Elektronik
®
is developed with due consideration to all resultant
environmental issues. When you dispose the equipment you should avoid environmental pollution.
For disposal of the transmitter the individual components must be sorted with care. The
housing consists of recyclable polycarbonate or metal (aluminium, Al Si 9 Cu 3). The
electronics must be collected as electronic scrap and disposed of according to the
regulations in force.
i
!
!
!
!
!
