Draft 02 - Sep 1 2015
Viking Mobile Radio Operating Manual
9-7
Tones & Error Messages
NO_PRIORITY
“No Priorty”
“NO PRIORTY”
“No Priorty”
This error occurs when attempting to use the conventional
Priority feature on a non-priority scan list.
NO_SERVICE
“No Service”
“NO SERVICE”
“No Service”
This error indicates that OTAR service is not available.
NO_SITE
“No Site”
“NO SITE”
“No Site”
This error indicates that no site with a verified ID is yet on the
dynamic site list. This applies to the Site Lock feature.
NO_UKEKS
“No UKEK”
“NO UKEK”
“No UKEK”
This error occurs when attempting to rekey with no UKEK.
NUM_CHNL_FAIL
“Channl Limit”
“CHANL LIMT”
“Channel Limit”
If seen upon startup, this error indicates that the radio has
been programmed with more channels than what it is
optioned for. This error is also indicated with 10 orange blinks
of the LED.
OUT_OF_RANGE
“Out Of Range”
“OUT OF RNG”
“Out Of Range”
This error indicates no control channel has been found for
trunking operation.
PARMS_FAILED
“Parms Fail”
“PARMS FAIL”
“Parms Fail”
There is no parameter file in the radio. This error will also be
indicated with 3 orange blinks of the LED.
RECEIVE_ONLY
“Rx Only”
“RX ONLY”
“Receive Only”
This error indicates that the selected channel is Rx only. This
can occur if transmit disabled is selected or a conventional
channel is configured with talkgroup 0.
REGISTRATION_DENY
“Reg Deny”
“REG DENY”
“Reg Deny”
This error indicates that a unit registration attempt has
received a DENY response from the system. The precise
reason for a DENY response is manufacturer dependent. One
common cause is that the unit ID is disallowed on the site/
RFSS that the radio is attempting to register on.
REGISTRATION_FAILED
“Reg Failed”
“REG FAILED”
“Reg Failed”
This error indicates that a unit registration attempt has
received a FAILED response from the system. The precise
reason for a FAILED response is manufacturer dependent.
REGISTRATION_REFUSED
“Reg Refused”
“REG REFUSD”
“Reg Refused”
This error indicates that a unit registration attempt has
received a REFUSED response from the system. The precise
reason for a REFUSED response is manufacturer dependent.
REKEY_FAIL
“Rekey Failed”
“REKEY FAIL”
“Rekey Failed”
This error indicates a failure in a rekeying process.
RESPONSE_ONLY
“Resp Only”
“RSPNS ONLY”
“Response Only”
This error indicates that the Unit Call/Call Alert setting to set to
Response Only.
Message Enumerations
Portable/SCH/LCH
Strings
Description
