Draft 02 - Sep 1 2015
Viking Mobile Radio Operating Manual
9-9
Tones & Error Messages
9.4
SZ System Reject Messages
The following messages are defined in the radio. Other messages will be displayed as a
number. Contact EFJ engineering for more information on a “numbered” reject message.
5
Corrupt Parms
The parameters checksum or other data is corrupted.
6
Unused
7
DSP Fail
This error indicates that the DSP failed to complete its startup
procedure at powerup.
8
RX Backend Fail
There is a communication failure between the DSP and the back
end ADC on the RF deck.
9
HC08 Init Fail
The HCO8 was not initialized correctly and cannot be accessed
for flash reads and writes, etc.
10
Channel Fail
The radio has been programmed with more channels than it
optioned for.
11
Encryption Fail
This error indicates that the main processor and the encryption
module have failed to complete their startup procedure at
powerup.
12
Bad ESN
This error indicates that the ESN of the radio is not valid. This
error is usually only seen in the factory when first programming
brand new logic boards.
Orange LED Blinks
Startup Failure
Description
Error String
Description
“ID Invalid”
The ID of the subscriber is invalid.
“Target Invalid”
The ID of the target is invalid.
“ID Disabled”
The ID of the substriber is disabled or not allowed to access the
system.
“Target Disabled”
The target ID is disabled or not allowed to access the system.
“Invalid Group”
The takgroup is not valid.
“Disabled Group”
The talkgroup is disabled or not allowed on the system.
“Feature Disabled”
The attempted feature is not allowed on the system.
“Clear Only”
Secure calls are not allowed for the target ID or are not allowed for the
current group.
“Secure Only”
Clear calls are not allowed for the target ID or are not allowed for the
current group.
“Over Budget”
Interconnect dollar limit exceeded by user.
“Not Allowed Site”
The subscriber’s ID is not allowed or the current
talkgroup is not allowed on the site.
“Override Invalid”
There is not call busy override.
