Draft 02 - Sep 1 2015
3-10
Viking Mobile Radio Operating Manual
General Operation
• A press-and-hold performs channel delete.
To copy a channel:
1
Navigate to the channel and select “channel copy”.
2
Select the destination, first the zone and then the channel.
3
These can be selected by the navigation pad or using direct entry.
4
If the destination channel exists, it is overwritten without warning.
When deleting a channel, first select a zone and then the channel to delete.
There are a number of restrictions in place to prevent you from causing problems with the
existing radio configuration. If you want to copy or delete a channel that is blocked by one
of these restrictions, the radio programming software can be used to make the change.
(Please contact your system administrator.)
3.1.10 Transmit Disable
Transmitting can be disabled on each conventional, SMARTNET, SmartZone, and P25
Trunking channel so that the channel is monitor-only. When transmitting is attempted on a
receive-only channel, “RX ONLY” (Standard Control Head) or “Receive Only”
(Lightning Control Head) is displayed and an error tone sounds.
Condition
Copy
Allowed?
Delete
Allowed?
The destination channel is the current
channel
No
No
The selected zone is full (255 Channels)
No
Yes
The radio has no free channels
No
Yes
The channel is a fire mode channel
No
No
The channel is a scan list channel
No
No
The channel is a RWS list channel
No
No
The channel is a global emergency
channel
No
No
