Draft 02 - Sep 1 2015
Viking Mobile Radio Operating Manual
3-15
General Operation
2
While sending a Status, the alias of the Status being sent is displayed.
3
Once the Status has been sent operation continues the same as the normal Status with
the exception being that only the PTT may be used to resend the Status while the
transmission is still active.
4
Once the status transmission is successful or fails, a success or failure message is
displayed.
5
After a success or failure, the radio will exit the status mode.
6
To exit before the Status finishes, either press the Clear button or the Single Touch
button assigned to Status.
3.2.2.4
Conventional Message
This is the same operation as Conventional Status except that a Message is being sent.
1
To send a Status, press and hold the Single Touch button assigned to Message.
2
While sending a Status, the alias of the Message being sent is displayed.
3
Once the Message has been sent operation continues the same as the normal Message
with the exception being that only the PTT may be used to resend the Message while
the transmission is still active.
4
Once the Message transmission is successful or fails, a success or failure message is
displayed.
5
After a success or failure, the radio will exit the Message mode.
6
To exit before the Message finishes, either press the Clear button or the Single Touch
button assigned to Message.
3.2.2.5
P25 Unit Call
In Armada the Unit Call can be set to Standard or Enhanced. Single Touch supports both
and they each operate the same as a normal Standard or Enhanced Unit Call. To answer a
unit call the PTT needs to be pressed after the Single Touch button is pressed and held.
To Send a Single Touch Unit Call
1
To send a Unit Call, press and hold the Single Touch button assigned to Unit Call.
2
For the radio to send, the Unit Call Usage in Armada under Systems(P25)
→
Lists
→
Call Settings must be set to Unlimited or List Only.
