Draft 02 - Sep 1 2015
Viking Mobile Radio Operating Manual
3-17
General Operation
3.2.2.7
P25 Status
1
To send a Status, press and hold the Single Touch button assigned to Status.
2
The Status alias programmed to Single Touch is displayed for one second.
3
Either an Ack Received message or a Status Fail message is displayed after the Status
has been sent.
4
Once the Status is sent, operation continues as normally would in a Status. For example
the same buttons are available for use as they would be by sending a Status through the
menu.
5
The Status is not able to be exited while sending unless it is canceled by another
function. The user must wait for the Ack or the Fail message.
3.2.2.8
P25 Interconnect
1
To start an Interconnect Call, press and hold the Single Touch button assigned to Inter-
connect.
2
The alias of the phone number being called will be displayed.
3
Once the call is started through Single Touch, operation continues as normal for
Interconnect Call.
4
To exit the call either press the Clear button or the Single Touch button assigned to
Interconnect.
5
To answer an Interconnect Call with the Single Touch button press and hold it.
6
Once pressed and held the incoming call will be answered and operation will continue
as would on a normal Interconnect Call answer.
3.2.2.9
SNSZ Unit Call
In Armada the Unit Call can be set to Standard or Enhanced. Single Touch supports both
and they each operate the same as a normal Standard or Enhanced Unit Call. To answer a
unit call the PTT needs to be pressed after the Single Touch button is pressed and held.
To Send a Single Touch Unit Call
1
To send a Unit Call press and hold the Single Touch button assigned to Unit Call.
2
For the radio to send, the Unit Call Usage in Armada under Systems (Smartnet/
Smartzone)
→
Lists
→
Call Settings must be set to Unlimited or List Only.
