18
E-flite Eratix 3D 25e ARF Assembly Manual
13. Use a hobby knife to pierce the covering for the
3mm x 30mm machine screw. Slide the screw into the
hole from the top of the wing. Slide a control horn
washer onto the screw, then thread the control horn
standoff onto the screw. Use a #1 Phillips screwdriver to
tighten the assembly.
Note
: Use threadlock on the control horn screw to
prevent it from vibrating loose.
14. Thread the nylon control horn onto the control
horn screw until the top of the horn is flush with the
top of the screw.
15. Slide a clevis retainer onto a nylon clevis. Thread the
clevis onto the 2
7
/
8
-inch (73mm) pushrod wire. Attach
the clevis to the control horn and slide the clevis retainer
over the forks of the clevis to secure it to the control horn.
